It is necessary for the surface to be completely covered with epoxy before proceeding with polishing. To prepare the surface, several sandings are required, starting with a grit of 500 or 600 to remove defects or unevenness in the finish. Then, it is recommended to sand with progressively finer dry or wet sandpaper such as 500, 800, 1000, 2000, and 3000, and finish with a fine or very fine polishing agent. The use of a low-speed polisher or rotary sander is advised. It is important to note that these steps should be carried out carefully to avoid damaging the surface.
How to restore or polish an epoxy table with scratches?
Last updated on September 18, 2023
Articles similaires
How to polish a surface finished with epoxy or lacquer?
What are the golden rules to follow to achieve a professional quality oil finish?
Sanding hardwood floors - Operating a floor sander
How to achieve optimal results with a manual belt sander?
Sanding hardwood floors - Renting the proper floor sanding equipment